Question detail
Forces and elasticity scenario: a box presses on a small contact area and changes pressure. Which answer best addresses Stretching and deformation and the objective to distinguish extension from total length in practical measurements?
Try the question, check the answer, then read the explanation to understand the curriculum point.
At a glance
MCQ
Type
practice
Style
Topic
Forces and elasticity
Question
- A. In the pressure pad scenario, apply extension to distinguish extension from total length in practical measurements while keeping elastic versus plastic deformation separate.
- B. In the pressure pad scenario, mix up elastic versus plastic deformation and ignore extension.
- C. Use a general revision statement without applying Stretching and deformation to the situation.
- D. Choose a different forces topic instead of explaining distinguish extension from total length in practical measurements.
Answer
The correct answer is: In the pressure pad scenario, apply extension to distinguish extension from total length in practical measurements while keeping elastic versus plastic deformation separate.
Explanation
The correct option is In the pressure pad scenario, apply extension to distinguish extension from total length in practical measurements while keeping elastic versus plastic deformation separate.. It is correct because the scenario says a box presses on a small contact area and changes pressure, which must be interpreted through Stretching and deformation. This directly supports the learning objective to distinguish extension from total length in practical measurements. Use values 8, 12, and 19 only if the question asks for a calculation. The answer earns credit by naming the relevant force or motion quantity, using units when needed, and avoiding the boundary error elastic versus plastic deformation.
Common mistake
Confusing total length with extension
Students often treat the measured length of a stretched spring as the extension, rather than subtracting the original length to find the change in length.
Remind students that extension (ΔL) is the difference between the stretched length and the original length: ΔL = L_stretched – L_original. Always record both lengths and calculate the extension separately before using it in Hooke’s law or energy equations.
Related flashcards
Flashcard 1 of 5
Related practice questions
Question 1 of 5
Choose an answer, get feedback, then move sideways through the set.